Join 60,000+ competitive exam aspirants
The advantage of reheating of steam in a turbine is that
It increases the efficiency of the turbine
It reduces the wears on the blades
It increases the work done through the turbine
All of above
It reduces the wears on the blades
Reheating of steam is a technique used in power cycles where steam is extracted from the turbine after partial expansion, reheated in the boiler, and sent back to the turbine. This process increases the cycle efficiency, prevents moisture formation in the low-pressure turbine stages, and increases the total work output of the turbine.
Reheating of steam is a technique used in power cycles where steam is extracted from the turbine after partial expansion, reheated in the boiler, and sent back to the turbine. This process increases the cycle efficiency, prevents moisture formation in the low-pressure turbine stages, and increases the total work output of the turbine.
WtotalтАЛ=WHPтАЛ+WLPтАЛ тАФ Total work output is the sum of work from High and Low-pressure turbines.
╬╖reheatтАЛ=QinтАЛQinтАЛтИТQoutтАЛтАЛ тАФ Cycle efficiency considering reheat heat addition.
In a standard Rankine cycle, steam expands until it reaches a low-pressure state where it becomes very wet. Reheating adds enthalpy to the steam, pushing the expansion line in the T-s diagram towards the superheated region. This ensures the steam quality at the turbine exit remains high, reducing blade erosion caused by water droplets while extracting additional work.
Reheating increases the mean temperature of heat addition, leading to higher thermal efficiency.
It significantly improves the quality of exhaust steam, preventing pitting and corrosion on turbine blades.
Reheating increases the specific work output, allowing for smaller turbine designs for a given power rating.
Increased thermal efficiency
Reduction in blade erosion
Increased work output per kg of steam
Increased capital cost due to complex boiler design
Requirement for additional piping and control systems
Slight increase in condenser heat load
Large-scale thermal power plants
Combined Cycle Gas Turbine (CCGT) systems
The process is effective only if the reheat pressure is approximately 20-25% of the initial boiler pressure.
Option B is correct because moisture content exceeding 10-15% causes mechanical erosion on blades; reheating keeps the expansion in the superheated region longer.
D is correct тАФ Reheating steam improves the thermal efficiency, protects turbine blades from erosion by reducing moisture, and increases the total enthalpy drop, thus increasing the work done.
Always remember that reheat, regeneration, and superheating are the three primary methods to improve Rankine cycle performance; reheat specifically targets turbine exit quality and efficiency.