Join 60,000+ competitive exam aspirants
The air gap between the yoke and armature is dc machine is kept very small
to avoid locking of the armature
to avoid overheating
to achieve a stronger magnetic field
all of the above
to achieve a stronger magnetic field
The air gap between the yoke and armature in a DC machine is kept minimal to reduce the reluctance of the magnetic circuit. A lower reluctance ensures that a given magnetomotive force (MMF) produces a larger magnetic flux, thereby increasing the efficiency and performance of the machine.
The air gap between the yoke and armature in a DC machine is kept minimal to reduce the reluctance of the magnetic circuit. A lower reluctance ensures that a given magnetomotive force (MMF) produces a larger magnetic flux, thereby increasing the efficiency and performance of the machine.
R=╬╝0тАЛAlтАЛ тАФ Reluctance of the air gap
╬ж=RFтАЛ тАФ Ohm's law for magnetic circuits
The magnetic flux produced by the field coils must cross the air gap to reach the armature. The magnetic reluctance R of a gap is proportional to its length l and inversely proportional to its area A and permeability ╬╝0тАЛ, given by R=╬╝0тАЛAlтАЛ. By minimizing l (the air gap), the reluctance R decreases, which according to Ohm's law for magnetic circuits ╬ж=RFтАЛ (where F is MMF), results in a stronger magnetic flux ╬ж for a given MMF.
Air gap reluctance is the dominant component of the total magnetic circuit reluctance in a DC machine.
A smaller air gap minimizes the required excitation current to achieve the desired flux density.
Mechanical clearance must still be sufficient to prevent physical contact (rubbing) between the rotating armature and stationary yoke due to tolerances or vibrations.
Higher magnetic flux density for the same field current.
Improved energy conversion efficiency.
Lower field excitation power requirement.
Requires tighter manufacturing tolerances and precise assembly.
Increased risk of mechanical friction (armature hitting the pole shoes) if bearings wear out.
Higher cogging torque effects.
DC motors in industrial drives.
DC generators for power supply units.
Traction motors.
Typical air gap values range from 0.5 mm to 5 mm depending on the machine size.
Option A is incorrect because while a tiny gap is good, the primary goal is magnetic efficiency, not just avoiding 'locking'.
Option B is incorrect as a smaller air gap does not directly prevent overheating; in fact, higher flux density can potentially increase iron losses if not managed correctly.
C is correct тАФ Keeping the air gap small reduces magnetic reluctance, which allows the machine to achieve a stronger magnetic field for a given field current.
Always remember the analogy: Reluctance in a magnetic circuit is equivalent to resistance in an electric circuit; smaller gap = less resistance to flux flow.