Join 60,000+ competitive exam aspirants
The interconnected system has following power plants
Nuclear
Steam
Diesel
Gas turbine
Hydro with storage
Run off the river
Pumped storage
Which of the above two power plants are used exclusively for supplying base loads?
1 and 5
1 and 2
1 and 6
2 and 6
1 and 6
Nuclear power plants and run-of-the-river hydro plants are classified as base-load plants because they operate continuously to meet the minimum demand of the grid. Their high capital costs and low operating costs, combined with the difficulty of quickly modulating output, make them unsuitable for peaking service.
Nuclear power plants and run-of-the-river hydro plants are classified as base-load plants because they operate continuously to meet the minimum demand of the grid. Their high capital costs and low operating costs, combined with the difficulty of quickly modulating output, make them unsuitable for peaking service.
Capacity┬аFactor=Max┬аPossible┬аEnergy┬аin┬аPeriodActual┬аEnergy┬аProducedтАЛ
Load┬аFactor=Maximum┬аDemandAverage┬аLoadтАЛ
Base-load power plants provide the steady, non-fluctuating component of the total electrical load, which is available 24/7. Nuclear plants run at high capacity factors due to refueling complexities and economic considerations, while run-of-the-river plants depend on the natural flow of water, which is treated as a continuous energy source to be utilized fully when available.
Base load plants must have low variable operating costs.
Nuclear fuel cycle management requires steady-state operation.
Run-of-the-river plants lack storage, forcing immediate generation of available water flow.
Gas turbines and diesel plants are expensive to run and used for short-term peaks.
Pumped storage is exclusively for peaking and load leveling, not base load.
Nuclear: Extremely low fuel cost per kWh
Run-of-the-river: No fuel cost and minimal environmental footprint
Nuclear: High capital cost and radioactive waste management
Run-of-the-river: Seasonal dependency on river discharge
Grid stability maintenance
Industrial heavy manufacturing steady supply
Nuclear and run-of-the-river plants have high capacity factors.
Options like Pumped Storage (7) and Diesel (3) are specifically classified as peaking plants, not base load.
C is correct тАФ Nuclear (1) and Run-of-the-river (6) plants are utilized as base-load plants due to their operational constraints and economic characteristics.
In competitive exams, remember the mnemonic: Base load is steady (Nuclear/Run-of-River), Peak load is flexible (Gas/Diesel/Pumped-Storage).