Join 60,000+ competitive exam aspirants
Which of the plants is suitable for peak load?
Diesel engine plant
Steam power plant
Nuclear power plant
Hydro electric plant
Diesel engine plant
Diesel engine power plants are classified as peak load plants because they exhibit quick starting, rapid synchronization, and high flexibility in handling sudden load fluctuations. Unlike steam or nuclear plants, which require long warm-up times, diesel plants can be brought online in a few minutes, making them ideal for meeting short-duration peak energy demands.
Diesel engine power plants are classified as peak load plants because they exhibit quick starting, rapid synchronization, and high flexibility in handling sudden load fluctuations. Unlike steam or nuclear plants, which require long warm-up times, diesel plants can be brought online in a few minutes, making them ideal for meeting short-duration peak energy demands.
PpeakтАЛ=V├ЧI├Чcos╧Х тАФ Instantaneous Power Output
╬╖thermalтАЛ=QinтАЛWoutтАЛтАЛ тАФ Thermal Efficiency
The principle involves internal combustion where diesel fuel is injected into compressed air within the engine cylinder, causing spontaneous ignition and rapid expansion of gases. This pressure drives the piston, converting chemical energy to mechanical energy via a crankshaft, which in turn drives an AC generator. The system has minimal thermal inertia, allowing for rapid load response.
Diesel plants have a lower capital cost but a higher operating cost due to fuel price.
They are typically used for peak loads (ranging from 100 kW to 50 MW).
They require no standby losses, unlike steam plants which need boiler firing.
Easily installed in remote or urban areas near the load center.
Quick starting and stopping
High thermal efficiency at partial loads
Low transmission costs (located near load center)
Less space required
High fuel cost
High maintenance and lubrication requirements
Cannot handle large overloads for long durations
Noise and vibration issues
Peak load stations for grid support
Emergency standby units for hospitals and data centers
Remote industrial power supply
| Feature | Diesel Plant | Steam Plant |
|---|---|---|
Starting Time | Few Minutes | Hours |
Standby Losses | Negligible | Significant |
Steam and nuclear power plants are primarily used as base load plants due to their large size, high efficiency at full load, and slow response to load changes.
Hydroelectric plants are versatile but often reserved for base load or spinning reserve depending on reservoir capacity.
A is correct тАФ Diesel engine plants are ideal for peak loads due to their rapid starting and ability to synchronize quickly with the grid.
Always remember the rule: Nuclear and Coal (Steam) are Base Load (Low flexibility/High capacity), while Diesel and Gas Turbine are Peak Load (High flexibility/Low capacity).