Join 60,000+ competitive exam aspirants
Why is wind turbine designed to stop operation at cut out velocity?
To protect turbine against damage
To make a quick stop in emergencies
To improve the efficiency
To adjust the blades in wind direction
To protect turbine against damage
Wind turbines are designed with a specific operating range; the cut-out velocity is the maximum wind speed at which the turbine can safely operate. Beyond this speed, the turbine must be shut down (braked) to prevent mechanical failure and structural damage due to excessive aerodynamic loads and high rotational stresses.
Wind turbines are designed with a specific operating range; the cut-out velocity is the maximum wind speed at which the turbine can safely operate. Beyond this speed, the turbine must be shut down (braked) to prevent mechanical failure and structural damage due to excessive aerodynamic loads and high rotational stresses.
P=21тАЛ╧БAv3CpтАЛ тАФ Power in wind where P is power, ╧Б is air density, A is rotor area, v is wind velocity, and CpтАЛ is power coefficient.
As wind speed approaches the cut-out limit, the aerodynamic forces acting on the blades reach the structural design limit of the turbine components, such as the gearbox and yaw drive. To prevent catastrophic failure, the control system triggers a shutdown sequence, which typically involves feathering the blades (rotating them out of the wind) and applying mechanical brakes to stop the rotor.
Cut-in speed: Minimum wind speed to start generating power.
Rated speed: Wind speed at which the turbine reaches its maximum rated power.
Cut-out speed: Maximum safety speed where the turbine stops to avoid structural fatigue.
Feathering is the primary method used to reduce torque at high wind speeds.
Prevents structural damage during storms
Increases longevity of mechanical components
Results in zero power output during extreme weather events
Requires complex automated control systems
Onshore wind farms
Offshore wind installations
Cut-out speeds are typically set between 20 to 25 m/s for commercial wind turbines.
Option B is incorrect because emergency stops are triggered by faults or maintenance requirements, not normal speed regulation.
A is correct тАФ The cut-out velocity serves as a safety threshold to prevent mechanical and structural damage to the turbine during high-wind conditions.
Always remember that wind turbine output is proportional to the cube of wind speed (v3), making control at high speeds critical for structural integrity.