Join 60,000+ competitive exam aspirants
With the same maximum voltage between conductor, the ratio of copper volumes needed in three phase, 3-wire system and single phase, 2-wire system is
4/3
3/4
5/3
3/5
3/4
The copper volume ratio is derived by comparing the conductor cross-sectional area required for a 3-phase 3-wire system and a 1-phase 2-wire system under the same maximum voltage stress and power transmission capacity. For a given power, voltage, and loss, the 3-phase system requires only 75% of the copper weight compared to a 1-phase 2-wire system, resulting in a ratio of 3/4.
The copper volume ratio is derived by comparing the conductor cross-sectional area required for a 3-phase 3-wire system and a 1-phase 2-wire system under the same maximum voltage stress and power transmission capacity. For a given power, voltage, and loss, the 3-phase system requires only 75% of the copper weight compared to a 1-phase 2-wire system, resulting in a ratio of 3/4.
VratioтАЛ=Volume1╧ХтАЛVolume3╧ХтАЛтАЛ=0.75
In a 1-phase 2-wire system, the maximum voltage between conductors is VmтАЛ. In a 3-phase 3-wire system, the voltage between conductors is VLтАЛ=VmтАЛ. Since the line current in 3-phase is ILтАЛ=3тАЛVLтАЛcos╧ХPтАЛ, the total cross-sectional area and volume are optimized due to the balanced phase distribution, leading to the reduction in conductor material requirements.
Maximum voltage stress is considered between conductors for both systems.
3-phase systems provide significant material savings in long-distance power transmission.
The calculation assumes equal power, equal line losses, and equal efficiency.
Lower conductor material cost
Higher transmission efficiency
Balanced load distribution
More complex switchgear requirement
Not economical for very small loads
High Voltage Transmission lines
Industrial motor distribution grids
| Feature | Reference | Comparison |
|---|---|---|
System Type | 1-phase 2-wire | 3-phase 3-wire |
This calculation assumes power factor is constant across both systems.
Option 4/3 is the inverse (1-phase to 3-phase) and is incorrect.
B is correct тАФ The ratio of copper volumes needed for a 3-phase 3-wire system to a 1-phase 2-wire system is 3/4 under identical maximum voltage and power constraints.
Remember that 3-phase systems are more efficient as they allow higher power delivery with fewer conductors and lower resistive losses for the same voltage limit.