Join 60,000+ competitive exam aspirants
With the same maximum voltage to earth, which of the following AC system with 0.8 power factor will need more copper in comparison to DC 2-wire system
Single phase 2-wire (midpoint earthed)
Single phase 3-wire
Three phase 3-wire AC system
Three phase 4-wire AC system
Three phase 4-wire AC system
To compare the copper requirement, we evaluate the volume of conductor material relative to a DC 2-wire system with the same maximum voltage to earth. A 3-phase 4-wire system requires more copper because the presence of the neutral wire and the phase angle influence (power factor = 0.8) increases the cross-sectional area required to maintain the same voltage drop and power delivery limits.
To compare the copper requirement, we evaluate the volume of conductor material relative to a DC 2-wire system with the same maximum voltage to earth. A 3-phase 4-wire system requires more copper because the presence of the neutral wire and the phase angle influence (power factor = 0.8) increases the cross-sectional area required to maintain the same voltage drop and power delivery limits.
VolumeтИЭV2├Чcos2(╧Х)P2├ЧLтАЛ тАФ Relationship between copper volume and power system parameters
VmaxтАЛ=VphaseтАЛ├Ч2тАЛ тАФ Peak voltage to earth constraint
The copper volume is proportional to the inverse square of the system voltage and the square of the current. In a 3-phase 4-wire system, the neutral current and phase-to-earth constraints force a higher conductor weight compared to systems with fewer wires or higher symmetry, especially when the power factor is less than unity (0.8).
Copper weight is inversely proportional to the square of voltage and power factor.
A 3-phase 4-wire system includes a neutral conductor, increasing the total conductor volume.
The 0.8 power factor increases current, necessitating larger conductor cross-sections to maintain transmission efficiency.
Provides both single-phase and three-phase supplies
Balanced utilization for mixed loads
Higher conductor material cost compared to 3-wire systems
Increased weight due to the fourth (neutral) conductor
Low voltage residential distribution
Commercial buildings with mixed lighting and motor loads
For the same maximum voltage to earth, the 3-phase 4-wire system is generally the most copper-intensive among the listed options.
Other systems like 3-phase 3-wire are significantly more efficient in copper usage because they omit the neutral conductor and maintain lower current density requirements.
D is correct тАФ The 3-phase 4-wire AC system requires the highest amount of copper because the addition of the neutral conductor and the operating power factor significantly increase the total conductor cross-sectional area needed.
Always remember that in power systems, the neutral wire in a 4-wire system significantly adds to the total weight of copper, especially when compared to systems where the neutral is absent or the load is perfectly balanced.