Join 60,000+ competitive exam aspirants
As per IS 13311 (part 1), the natural frequency of transducers for a path length of more than 1500 mm is _________.
greater than or equal to 10 kHz
greater than or equal to 50 kHz
less than 5 kHz
greater than or equal to 20 kHz
greater than or equal to 20 kHz
According to IS 13311 (Part 1), the selection of ultrasonic transducers is dependent on the path length of the concrete member being tested. For a path length exceeding 1500 mm, transducers with a natural frequency of 20┬аkHz to 60┬аkHz are recommended to ensure proper wave propagation and signal attenuation management.
IS 13311 (Part 1): 1992, Section 5.3.1
According to IS 13311 (Part 1), the selection of ultrasonic transducers is dependent on the path length of the concrete member being tested. For a path length exceeding 1500 mm, transducers with a natural frequency of 20┬аkHz to 60┬аkHz are recommended to ensure proper wave propagation and signal attenuation management.
V=TLтАЛ тАФ where V is the pulse velocity, L is the path length, and T is the time of travel.
Ultrasonic Pulse Velocity (UPV) testing utilizes mechanical stress waves. Higher frequency transducers provide better resolution but suffer from higher attenuation in concrete; conversely, lower frequencies penetrate deeper but have lower resolution. For longer path lengths, lower frequency transducers are preferred to overcome the substantial attenuation caused by the concrete medium.
Lower frequency transducers (20┬аkHzтИТ60┬аkHz) are used for long path lengths.
Higher frequency transducers (100┬аkHzтИТ150┬аkHz) are used for short path lengths.
The test determines the homogeneity, voids, and cracks in concrete.
Pulse velocity is sensitive to the moisture content and path length of the specimen.
Non-destructive in nature.
Provides information about concrete uniformity.
Affected by the presence of steel reinforcement.
Influenced by the moisture content and age of concrete.
Detection of honeycombing and voids.
Estimation of concrete strength.
Monitoring deterioration over time.
For path lengths below 500 mm, frequencies of 100 kHz to 150 kHz are generally used.
The choice of frequency is a trade-off between the depth of penetration and the resolution of the defects detected.
D is correct тАФ As per IS 13311 (Part 1), transducers for path lengths greater than 1500 mm should have a natural frequency of at least 20 kHz.
Remember that in UPV testing, longer path length requires lower frequency to combat attenuation, which is the inverse of many other NDT methods where higher frequency is preferred for better resolution.