Join 60,000+ competitive exam aspirants
During the calibration of a rectangular suppressed weir in a 40 cm crest width laboratory channel, the discharge passing over the weir was measured volumetrically. What is the coefficient of discharge of the weir if it was found to pass a discharge of 0.025 m 3 /sec under the head of 0.1 m?
CdтАЛ = 0.89
CdтАЛ = 0.92
CdтАЛ = 0.75
CdтАЛ = 0.66
CdтАЛ = 0.66
The discharge over a rectangular weir is determined by the Francis formula or the general weir equation. By substituting the given parameters into the discharge equation Q=32тАЛCdтАЛL2gтАЛH3/2, the coefficient of discharge CdтАЛ can be isolated and calculated.
IS 9140:1988
The discharge over a rectangular weir is determined by the Francis formula or the general weir equation. By substituting the given parameters into the discharge equation Q=32тАЛCdтАЛL2gтАЛH3/2, the coefficient of discharge CdтАЛ can be isolated and calculated.
Q=32тАЛCdтАЛL2gтАЛH3/2 тАФ The general discharge formula for a rectangular weir, where Q is discharge in m3/s, L is crest width, g is acceleration due to gravity, and H is the head.
The weir acts as a hydraulic obstruction that forces flow to contract and accelerate over the crest. The discharge coefficient CdтАЛ accounts for the energy losses due to viscosity and the contraction of the nappe as it passes over the weir crest.
Given Q=0.025m3/s, L=0.4m, and H=0.1m.
Taking g=9.81m/s2, the calculation is 0.025=32тАЛ├ЧCdтАЛ├Ч0.4├Ч2├Ч9.81тАЛ├Ч(0.1)1.5.
Simplifying gives 0.025=CdтАЛ├Ч0.2666├Ч4.429├Ч0.0316.
Solving for CdтАЛ yields approximately 0.66.
Simple construction
Provides accurate flow measurement in open channels
Sensitive to approach velocity
Head loss is significant
Irrigation channels
Laboratory fluid mechanics setups
The standard value for CdтАЛ in many experimental setups for suppressed rectangular weirs typically ranges between 0.60 and 0.68.
Options A, B, and C are mathematically incorrect based on the provided experimental variables.
D is correct тАФ The calculated coefficient of discharge using the weir formula with the given parameters is approximately 0.66.
Always ensure the units of head and width are consistent (SI units) before calculating CdтАЛ to avoid magnitude errors in exams.