Join 60,000+ competitive exam aspirants
For a very deep footing in loose sand, the type of soil failure will be:
cracking shear failure
general shear failure
punching shear failure
local shear failure
punching shear failure
For a very deep footing in loose sand, punching shear failure occurs because the soil lacks the necessary density to form a clear failure surface. Unlike shallow footings where shear surfaces can propagate to the ground level, deep foundations in loose soil experience significant vertical displacement with minimal radial deformation, resulting in the footing punching through the soil.
IS 6403:1981
For a very deep footing in loose sand, punching shear failure occurs because the soil lacks the necessary density to form a clear failure surface. Unlike shallow footings where shear surfaces can propagate to the ground level, deep foundations in loose soil experience significant vertical displacement with minimal radial deformation, resulting in the footing punching through the soil.
BDfтАЛтАЛ>4 тАФ condition for deep footing consideration
IDтАЛ<0.35 тАФ relative density indicating loose state for sand
In loose sand, the soil compressibility is high. When a load is applied to a deep foundation, the soil grains rearrange into a denser state directly beneath the base. This vertical compression dominates the behavior, preventing the formation of a continuous slip surface reaching the surface, thereby leading to 'punching' rather than 'general' or 'local' shear failure.
Punching shear failure is characteristic of loose, compressible soils.
General shear failure is associated with dense, incompressible soils.
Local shear failure represents an intermediate state between general and punching failure.
The depth-to-width ratio (DfтАЛ/B) influences the mode of failure significantly.
Prevents catastrophic sudden surface heaving observed in general shear failure.
Provides a predictable mode of failure for deep foundations in loose deposits.
Leads to large settlement magnitudes which may exceed serviceability limits.
Reduces the ultimate bearing capacity compared to dense soil conditions.
Design of pile foundations in soft or loose granular strata.
Deep foundation systems in marine or reclaimed loose sandy soils.
General shear failure usually occurs in dense sand with relative density IDтАЛ>70%.
Local shear failure typically occurs in medium-dense sand with relative density IDтАЛтЙИ35%тИТ70%.
Option A is incorrect as 'cracking' is not a primary failure mode classification for soil footings.
Option B and D are incorrect because they occur in dense and medium-dense soils respectively.
C is correct тАФ Punching shear failure occurs in very deep footings in loose sand due to high soil compressibility and lack of lateral resistance.
Always remember the trend: General shear is for dense/stiff soils, Local shear is for medium-dense/medium-stiff, and Punching shear is for loose/soft soils.