Join 60,000+ competitive exam aspirants
Which of the following consistency limit of soil is indicated by rolling the soil into a thread of 3 mm, and it begins to crumble.
Liquid limit
Plastic limit
CasagrandeтАЩs limit
Shrinkage limit
Plastic limit
The plastic limit is defined as the minimum moisture content at which a soil sample, when rolled into a thread of 3 mm diameter, begins to crumble. It represents the transition point between the plastic state and the semi-solid state of cohesive soils.
IS 2720 (Part 5): 1985
The plastic limit is defined as the minimum moisture content at which a soil sample, when rolled into a thread of 3 mm diameter, begins to crumble. It represents the transition point between the plastic state and the semi-solid state of cohesive soils.
IpтАЛ=wLтАЛтИТwpтАЛ тАФ represents the Plasticity Index, where wLтАЛ is the liquid limit and wpтАЛ is the plastic limit.
IcтАЛ=IpтАЛwLтАЛтИТwnтАЛтАЛ тАФ defines the Consistency Index, where wnтАЛ is the natural moisture content.
As water is removed from a plastic soil, the electrochemical forces of attraction between clay particles increase. At the plastic limit, the soil moisture is reduced to the point where the film of water surrounding particles is insufficient to maintain the plastic bond during mechanical manipulation (rolling), leading to brittle failure or crumbling at the specific 3 mm diameter.
The 3 mm thread test is a standardized empirical method to identify the lower boundary of the plastic range.
Plastic limit tests are only applicable to cohesive (fine-grained) soils like silts and clays.
If the soil crumbles at a diameter greater than 3 mm, the moisture content is below the plastic limit.
At the plastic limit, the soil is considered to have high shear strength compared to its liquid state.
Simple, field-conductible test without specialized heavy equipment.
Essential for soil classification systems like the Unified Soil Classification System (USCS).
Subjective result depending on the operator's experience.
Difficult to perform accurately on very silty or sandy soils with low plasticity.
Calculating the Plasticity Index for engineering classification.
Determining the state of consistency of fine-grained foundation soils.
Estimating the compressibility and permeability potential of clays.
Standard procedure requires the soil to be prepared by passing through a 425 micron IS sieve.
Option A (Liquid limit) is determined by the Casagrande cup apparatus, not by rolling.
Option C (CasagrandeтАЩs limit) is a distractor; Casagrande developed the liquid limit device, not a distinct consistency limit named after himself.
Option D (Shrinkage limit) is the moisture content where further loss of water does not cause a decrease in soil volume.
B is correct тАФ The plastic limit is precisely the moisture content where a 3 mm diameter soil thread starts to crack or crumble under manual manipulation.
Always remember that Plasticity Index (IpтАЛ) is a measure of the range of water content over which the soil remains plastic; a higher IpтАЛ indicates higher clay content and swelling potential.