Join 60,000+ competitive exam aspirants
Which of the following is NOT the remedial measure to prevent water hammer through pipes?
Drain your pipes and refill them to create new air chambers
Tighten mounting straps to hold pipes in place
Creating vacuum by closing valve
Installing water hammer arrestors
Creating vacuum by closing valve
Water hammer is a pressure surge caused by the sudden stop or change in direction of fluid flow. Creating a vacuum by closing a valve is not a remedial measure; rather, it is a dangerous practice that can cause cavitation, collapse of pipe walls, and contribute to the very phenomenon one seeks to prevent.
IS 12251:1987
Water hammer is a pressure surge caused by the sudden stop or change in direction of fluid flow. Creating a vacuum by closing a valve is not a remedial measure; rather, it is a dangerous practice that can cause cavitation, collapse of pipe walls, and contribute to the very phenomenon one seeks to prevent.
c=╧Б(1+EtKDтАЛ)KтАЛтАЛ тАФ Wave speed calculation for water hammer
P=╧Бc╬Фv тАФ Joukowsky pressure surge formula
When a fluid in motion is suddenly stopped, its kinetic energy is converted into pressure energy, causing a high-pressure wave to propagate back through the pipe. This wave creates shock loads on the pipe wall and fittings. Remedial measures involve slowing the valve closure time or using surge control devices to dissipate this energy.
Water hammer magnitude is directly proportional to fluid density, wave speed, and change in velocity.
Gradual valve closure reduces the intensity of the pressure surge.
Air chambers, surge tanks, and pressure relief valves are standard mitigation tools.
Vacuum conditions inside a pipe can lead to implosion or suction of external contaminants.
Arrestors effectively cushion shock waves.
Proper mounting reduces vibrations during pressure surges.
Excessive pressure can burst pipes and damage sensors.
Repeated water hammer events lead to fatigue failure in piping systems.
Hydraulic power plants
Municipal water supply distribution networks
Industrial process piping
Option C is incorrect because creating a vacuum encourages bubble formation, which upon collapse causes pressure spikes (cavitation erosion), exacerbating the system's instability.
Option A helps restore cushioning capacity of existing surge suppression systems.
Option B ensures the mechanical integrity of the pipeline under impulse loading.
C is correct тАФ Creating a vacuum by closing a valve is physically dangerous and induces cavitation rather than preventing water hammer.
Always remember the Joukowsky rule: the surge pressure depends primarily on the rate of change of fluid velocity; longer valve closure times result in lower peak pressures.