Join 60,000+ competitive exam aspirants
When hooks are formed in deformed bars, the internal radius of the bend should be at least ____ times the diameter of the bar.
two
three
four
six
four
According to IS 456:2000, for deformed bars, the internal radius of the bend for hooks should be at least 4 times the diameter of the bar (4╧Х). This is a mandatory requirement to ensure the durability of the reinforcement and prevent steel fatigue at the bend location.
IS 456:2000 Clause 26.2.2.1
According to IS 456:2000, for deformed bars, the internal radius of the bend for hooks should be at least 4 times the diameter of the bar (4╧Х). This is a mandatory requirement to ensure the durability of the reinforcement and prevent steel fatigue at the bend location.
RminтАЛ=4╧Х тАФ minimum internal radius of bend for deformed bars
LdтАЛ=4╧ДbdтАЛ╧Х╧ГsтАЛтАЛ тАФ development length formula where bend radius influences stress distribution
Bending reinforcement bars induces high compressive stresses on the inner surface and tensile stresses on the outer surface of the bend. If the radius of curvature is too small, the steel bar experiences excessive strain at the inner fiber, which can lead to micro-cracking or localized failure within the steel matrix. Providing a minimum radius of 4╧Х distributes these bending stresses over a sufficient length, preventing damage to the concrete core and the steel reinforcement itself.
For mild steel (plain bars), the minimum radius is 2╧Х.
For deformed bars (HYSD), the minimum radius is 4╧Х.
Hooks are essential for proper anchorage of reinforcement in concrete.
Bending should be done cold to avoid loss of material properties in high-strength bars.
Prevents stress concentration at the bend point.
Ensures effective bond between concrete and reinforcement.
Maintains structural integrity of the steel bar during and after installation.
Requires specialized mechanical bending tools.
Increased bend radius leads to slightly longer cut lengths of bars.
Beam-column junctions
Footing reinforcement
Stirrups and ties in columns
The code specifies different radii for various steel grades and bar types to ensure the steel remains within its elastic limit during the bending process.
Option A (2╧Х) is the requirement for mild steel plain bars, not deformed bars.
Option B (3╧Х) and Option D (6╧Х) are incorrect as they do not align with the standard provisions for hook bending in IS 456.
C is correct тАФ For deformed bars, the internal radius of the bend must be at least 4 times the bar diameter to prevent damage to the steel.
Remember that for stirrups and ties, the bend radius requirement is usually 2╧Х for mild steel and 4╧Х for HYSD bars; always check the bar type in the question.