Join 60,000+ competitive exam aspirants
A cube of side 150 mm is immersed in oil and subjected to a hydrostatic pressure of 5 MPa. If the bulk modulus of the material is 150 GPa, what is the volumetric strain produced?
3.33├Ч10тИТ5
1.33├Ч10тИТ4
2.33├Ч10тИТ3
1.67├Ч10тИТ5
3.33├Ч10тИТ5
Volumetric strain is defined as the change in volume per unit original volume when a body is subjected to hydrostatic pressure. It is calculated using the bulk modulus of the material, which represents the material's resistance to uniform compression.
Volumetric strain is defined as the change in volume per unit original volume when a body is subjected to hydrostatic pressure. It is calculated using the bulk modulus of the material, which represents the material's resistance to uniform compression.
evтАЛ=KpтАЛ тАФ Volumetric strain formula under hydrostatic pressure
K=volumetric┬аstrainpтАЛ тАФ Definition of Bulk Modulus
When a cube is subjected to uniform hydrostatic pressure p on all its faces, the decrease in volume is proportional to the pressure applied. The Bulk Modulus K is defined as the ratio of hydrostatic pressure to the resulting volumetric strain. The relation is given by K=evтАЛpтАЛ, where evтАЛ is the volumetric strain.
Volumetric strain is dimensionless.
Pressure p=5┬аMPa=5├Ч106┬аPa.
Bulk Modulus K=150┬аGPa=150├Ч109┬аPa.
The side length of the cube (150 mm) is redundant information for calculating the strain itself.
Direct application of Hooke's Law for volumetric deformation.
Simplified calculation due to uniform pressure distribution.
Assumes material is perfectly linear-elastic.
Does not account for non-uniform stress conditions.
Stress analysis in pressure vessels.
Hydraulic system design.
Geotechnical soil compression analysis.
Calculation: evтАЛ=150├Ч1095├Ч106тАЛ=150,0005тАЛ=30,0001тАЛтЙИ3.33├Ч10тИТ5.
Option B, C, and D are incorrect because they result from incorrect conversion of units or algebraic errors in the division.
A is correct тАФ The volumetric strain is calculated as the ratio of hydrostatic pressure to the bulk modulus, yielding 3.33├Ч10тИТ5.
In competitive exams, always check unit consistency first. Convert all pressures to Pa (N/m2) and moduli to Pa before performing the division to avoid powers-of-ten errors.